A dab rig is only as good as the parts on it. Swap in a better banger, add a carb cap or drop in some terp pearls, and the same rig can hit completely differently. This collection has all the dab rig parts and accessories you need to build out your setup or replace what’s worn out, all shipped discreetly across Canada.

Parts of a Dab Rig

If you’re new to dabbing, here are the main parts of a dab rig and what each one does:

Banger or nail: the piece you heat up and drop your concentrate into. Most are quartz, but you’ll also see titanium and ceramic.
Carb cap: a small cap that covers the banger to trap heat and control airflow, so your dab vaporizes at a lower temperature.
Joint: where the banger connects to the rig. It’s usually 10mm, 14mm or 19mm, and either male or female.
Water chamber: the body of the rig that holds water to cool and filter the vapour. Some include a percolator or recycler.
Mouthpiece: where you inhale.

A few extras round it out: terp pearls spin inside the banger for even heat, a reclaim catcher collects leftover oil before it reaches your rig, a dab tool loads your concentrate, and a torch or enail heats everything up.

Shop Dab Rig Parts

Quartz Bangers and Nails

The banger has the biggest effect on flavour. Browse standard quartz bangers plus terp slurpers, XL and thick-bottom bangers that hold heat longer, domeless nails, and e-bangers made to fit enail coils.

Carb Caps

From bubble caps to directional caps, a carb cap gives you more control over heat and airflow, which means more flavour from every dab.

Terp Pearls

Terp pearls sit inside your banger and spin when you pull, spreading heat and concentrate evenly across the bottom.

Reclaim Catchers

A reclaim catcher sits between the banger and the rig, trapping leftover oil so it doesn’t end up in your water. Your glass stays cleaner, and you can save the reclaim.

Dab Tools and Torches

A good dab tool makes loading sticky concentrates easy, and a reliable dab torch heats your banger fast. Prefer to skip the torch? Check out our enails.

How to Match Parts to Your Rig

Before you order, check three things on your rig:

Joint size: 10mm, 14mm or 19mm. Your banger has to match.
Male or female: a rig with a female joint needs a male banger, and the other way around.
Angle: match the banger’s angle (45 or 90 degrees) to your rig’s joint so the bucket sits level.

If your parts don’t line up, an adapter can usually bridge the gap.

Can You Use a Dab Piece on a Bong?

Yes. Swap your bowl for a banger, using an adapter if the joint sizes don’t match, and your bong can handle concentrates. The bigger chamber does spread out the vapour, though, so a dedicated dab rig will give you better flavour.

For more ways to dial in your setup, see our dab mats and the full weed accessories collection.